ARRI

For SkyPanel S60 LED Softlight Creates Omni-Directional Light Softens Light Output Removable Skirt Controls Light Spill Mounting Bracket Included Made in the USA Learn More

Holds Two Pairs of Studio Headphones Fits Stand Diameters up to 1.2" Sturdy Metal Construction Durable Threaded Locking Knob Learn More

Lensless MAX Technology: Easy to use Light output comparable to 1,200 W fixture Smallest lamphead with MAX Technology reflector Highly mobile for a wide range of uses Focusable between 15° and 60° Cross-Cooling allows safe operation even at 90° tilt Uses existing 230 & 245 mm accessories from ARRI True Blue D12 and from Chimera Compensation for Cable Losses (CCL) Uses existing 575 to 1,800 W cables with international connector Suitable for high frame rate images IP Rating IP23 Tilt locks to hold heavy accessories stable Learn More

5 Pin XLR Female to 5 Pin XLR Male Shielding, prevent transmission interferences Learn More

LAMP HMI 1800 /SE OSRAM G38 SKU: 5302171 MFR: L2.37590.0 MODEL: L2.37590.0 Learn More

Light Aperture: 50.4 x 34.4" 4kW Tungsten Softlight Equivalent Full Gamut RGB+W Color Control Color Temperature: 2800-10000K Hue and Saturation Control Beam Angle: 105° Built-In LumenRadio CRMX Wireless DMX Wired & Wireless DMX with RDM Support Advanced Dynamic Effects and Programming Universal 90-250 VAC Power Supply Unit Learn More

. Learn More

The Silver/Blue, Pole Operated L7-C LE2 Color LED Fresnel with powerCON Cable is part of ARRI's continuing effort to replace traditional Fresnels with powerful LED versions that offer unprecedented color control. The L7-C LE2 shares many characteristics with its predecessor, but the most obvious improvement is a 25% boost in power, increasing the light's tungsten equivalency from 750W to 1000W. This pole-operated version is meant for overhead mounting on pipe lengths or a grid. Pan, tilt, and focus are controlled from below with an optional pole using the 3 corresponding cups on the unit's special yoke. The key characteristic of any Fresnel is flood-to-spot capability, and the L7-C LE2 meets and exceeds expectations with an impressive beam angle of 15-50°. There's no learning curve when swapping out L7-C LE2 fixtures for fixtures with standard Fresnels. In fact, you're not going to be moving them around or juggling scrims in high places thanks to the 100 - 0% on-board dimming. The L7-C LE2 is a "fully tune-able" white light source too, allowing you to match existing fixtures from a warm 2800K to ice-blue 10,000K. The on-board controller allows manual intensity control as well as color temperature and +/- green. Specific color shades and skin tones can be matched through the full gamut color mixing feature. All functions can be controlled via DMX, an ideal feature for broadcast studios. The hybrid cooling system allows for cooling both actively (with a fan) or passively (without a fan) for times when the set needs to be dead quiet. The L7-C LE2's 1000W equivalent output draws only 160W during normal operation, making possible a savings of a 75% over similar output tungsten lights. And low heat means lower AC bills in the studio. You can actually run 9x L7-C LE2's from a 20A, 120VAC outlet as opposed to two 1000W or three 650W standard fixtures. Learn More

. Learn More